How to Remove and Replace an Evolis Pebble Printhead

Our technical area is busy with different questions our customers have about printers and how customers can get the most efficient operation from them. One popular question about the Evolis brand printers is about the printhead removal and replacement. The following video was prepared to demonstrate how to remove a printhead from the Evolis Pebble printer and then replace it wil a different printhead.

Steps:
1. Remove the hopper.
2. Open the top cover.
3. Push the support mechanism in to release the printhead.
4. Slide the printhead up and over the metal holder.
5. Unplug the wire harness.
6. Reverse the steps to put the new printhead into place.

Once the above steps are completed, the printer is ready for use.

If you need information about the Evolis printer brand, please contact our ID card experts at 888-485-4696.

Leave a Reply

Your email address will not be published. Required fields are marked *

eleven − eight =