Posted on Leave a comment

HID Access Card Printing Tips

When printing your HID Access cards follow these instructions to achieve best results. Start by printing a test card with a regular CR80 PVC Card to ensure your template and design are up to your standards, then;

– Always check cards for manufacturing debris. Sometimes there are small pieces of vinyl on the card. Carefully clean cards using 99% pure Isopropyl alcohol and a soft, lint free cloth.

– The office where you print the cards should be neat, clean and free of airborne particles. If not purchase a dust cover for when the printer is not in use.

– Check the printer’s roller frequently. Clean the printer roller after printing 50 cards (or fewer).

– Fine scuff marks may appear on the surface of cards. These marks do not affect the printer, nor the printed images. These scuff marks occur during final inspection and testing.

– Printer manufacturers discourage printing cards which are pre¬punched. The slot edge may tear the printer ribbon or interfere with card position sensors. Therefore, print your cards first, then slot punch them. For cards that are already punched, do not print in the area near the slot. If the card has an embedded contact chip, keep the printing at least .0625 in [1.5875 mm] away from its edges.

As always for information contact an expert at Safe-Card ID Services today.

Leave a Reply

Your email address will not be published. Required fields are marked *

three × four =