Zebra P330i – Using the Single Card Feeder

 

To set up the Zebra P330i printer for feeding single cards, follow the steps listed in the video.

First, the driver setting must be changed.
1. Empty the card feeder by removing the cards.

2. Use the eject command to remove the remaining id card in the printer.

a. Open the printer properties menu.
b. Select the device settings tab.
c. Go to the tools menu.
d. There are two eject card buttons to select from:

i. A button to eject the cards from the print engine.
ii. A button to eject the cards from the feeder and the print engine.

Second, insert the card into the slot under the feeder lid on the right side of the printer.

Third, the card will automatically be drawn into the printer with the print job is sent.

Find out specific information about Zebra Printer models:

Zebra P110i
Zebra P330i
Zebra P430i

For other Zebra printing tips see the following videos:

Zebra P330i – ID Card Printing Tips

Zebra P330i – Installing A Print Ribbon

Zebra P330i – Loading PVC Cards

Zebra P330i – Installing Printer Drivers

Zebra P330i – Installation Tips

4 thoughts on “Zebra P330i – Using the Single Card Feeder

  1. Pingback: Zebra P330i – Installing ID Card Printer Drivers | SafeCardID.com

  2. Pingback: Zebra P330i – Installing an Extended Card Feeder | The Medifast Blog

  3. Pingback: Zebra P330i – Installing an Extended Card Feeder | Betty´s Design

  4. Pingback: Zebra P330i – Clearing a Card Printer Jam | Betty´s Design

Leave a Reply

Your email address will not be published. Required fields are marked *

15 − nine =